Avid Pharmaceuticals

The cost structure with the lower breakable volume has the lower systematic risk. Fluctuations in sales volume has an impact on net income. Because there is no certainty, Waver must be ready for increases and decreases in sales if the new equipment is purchased. It is important for Waver to understand that the caller-out leave alone non always be at normal direct levels. Some quantifys to a greater extent units give need to be relieve oneselfd and often cartridge holders, less units will need to be produced due to the demand in sales. Fluctuations in demand will affect the bottom line, as seen in the examples above. ) What other factors should Waver consider in making this purpose? Will the quality of the product remain the same? Is the machine more efficient than the workers? Will time be saved? Can the machine produce more than 60,000 units per year? How many units can the equipment produce in a year, while maintaining a quality product? Can the company charge more for the p roduct if there is an increase in quality? How will this equipment affect Waver long-term? short? Will upgrades be needed (added expenses)? How quickly will the equipment be outdated? How quickly can the equipment be installed?Will there be a loss of manufacturing products while the equipment is being setup? Will the company lose money during setup due to lack of production? How will this new piece of equipment exhibition on the companys financial statements? Will it be depreciated? What form of depreciation? Are there new plus conversions that the accounting department will have to record? Do the product be and/or intent costs change? Is it possible to make other argonas more efficient, therefore, reducing fixed or varying costs? What company makes the manufacturing equipment? Is the company successful/reputable?Is the company new? Is the return on the investment satisfactory to board members and owners? How does the new equipment affect the employees? Will supererogatory discipline be needed? Who will operate and manage this new equipment? How difficult would it be to get service if repairs were needed? How dependable are the service repair people? Will Waver have to hire a full time employee to fix the repairs? This salary is an additional expense. How dependable is the machine? Will the equipment affect the factory layout, efficiency, create cyanogenetic smells or be too loud for workers to be near it?Will customer satisfaction be increased? Will the employees operating the machine be paid more, therefore, increasing salary Will planning occur? This is an added expense. Are there enough Jobs to reassign all employees displaced to new Jobs within Waver? How will Waver communicate this large change to its employees? How much does the machine cost? Are there additional variable costs that will be incurred? (4) What is your recommendation? This does non look bid a well-grounded investment for Waver. The return on investment is low at the normal 6 0,000 operating volume. The fixed costs are large, Jumping by 476,000.That is a large increase when the sales at normal operating conditions will only yield an extra $4,000. It is non worth the expense. In the beginning, the equipment may be thudding to operate at normal volume due to set up, training, glitches, etc. There may be a length of time where Waver is not able to produce and sell 60,000 units per year, which will violate Wavers bottom line (as seen in the 25% volume decrease in example above). The new equipment seems like a risky investment. The choice of production structure (with the new equipment or without) depends on the expected hereafter sales.If Waver was certain they could produce and sell more than 60,000 units per year, this may be an investment worth expression into, however, this is an unknown. Making a little less than the 60,000 units (59,500 units), would put Waver in the same position had they not purchased the new equipment. This point at which both cost structures intersect is what is relevant. From a managements perspective, this new equipment is really not a good idea. There are too many What ifs and too many personnel and training issues that could be factors. I would not recommend purchasing this new equipment for Waver.